No.14 Competing Interests

Not a new embankment but the same paper and paste techniques used to replace the coving and cover the opening for the old Central Heating flue!



The last fortnight has been dominated by swapping out the oil fired boiler for a heat pump, and making good the plaster and paintwork.  Crawling around in the eaves makes a change from ballasting.  Not sure which I most prefer!



Since my last post, ballasting of the mid-level single track junction has been completed.  It is maybe reminiscent of central Wales with an ex LNWR connection to an essentially ex GWR line.  The LNWR had running rights to the junction  - but not the branch terminus.  The shed to the side of the junction is supposedly of GWR origin, the view below was obviously taken on a Sunday.




Location: Dumfries and Galloway, UK

Comments

Post a Comment

Popular posts from this blog

No.123 Chocolate and Cream and BR1s – the Replica Railways Restaurant Buffet

Image
This Post describes some modifications that I have made to a Replica Railways BR Mk1 RB. Previously i have modified the Mainline Maroon RB by fitting Finecast glazing, wire handrails and Bachmann close coupling mechanisms. I promised myself that I would do the same for the chocolate and cream Replica BR(WR) RB. Success! Replica Railways BR(WR) Restaurant Buffet on BR1 Bogies First task - find a suitable coach! Replica Railways Mk1 RB from around 1992 Models are bit like London buses. When I first started looking for a BR(WR) RB there didn’t seem to be any around and eventually my coach came from Australia. Then suddenly there were lots available here in the UK. On opening the box I was surprised to discover that Replica had painted the solebars chocolate to match the lower body panels – why? Was someone confused by the blue solebars ion the blue and grey version? They should be black and they can be over painted with new transfers added from the P...
Read more

No.98 The Peco Streamline 3 Way Point.

Image
The Peco Streamline 3 Way point is an extremely useful space saving device. This Post is prompted because I had to sort out a couple of problems with the installation of my own three way point. I was also aware that other modellers   were finding difficulties with the operation and installation of their 3 way points. The design of the point is symmetrical and has the appearance of a LH point being placed directly on top of a RH point. As a consequence the construction of the point is quite complex and the point requires careful handling especially during installation. When first marketed by Peco the point was only available with ‘Insulfrog’.  The view below shows my first ‘Insulfrog’ point but reinstalled on my second layout. Peco Code 100 3 Way Insulfrog Point – the Park View Layout 1990s The big advantage of the ‘Insulfrog’ point is that it does not require any separate electrical switching and hence is suitable for manual or simple mechanical operation. My...
Read more

No. 152 Remotoring a Hornby Q6

Image
With all the rain outside putting a stop to gardening I have been grounded and have used the opportunity to tackle some longstanding issues.  Hornby first released their Q6 models in June 2016.  Having being raised in Middlesbrough I had to take delivery of two versions, an Early Emblem and one with a Late Crest.  They were tested and given a run around the layout before being stored away to make room for some BR (WR) trains. Q6 63443 Hornby R3425 February 2018 and Hornby released a further Early Emblem version.  I dug out my two original models and ran all three together.  It soon became obvious that one of the first models, number 63443, was a much slower runner.  On handling the model I was shocked to realise just how hot the bodyshell had become around the motor.  With further running I could well imagine melting the smokebox. Some research showed a problem with Hornby motors of a similar vintage.  My engine was too old to return for a ...
Read more